Manual

Rev F www.lmtdefense.com Page
29
REPLACING ACCESSORIES
• Replace the sights, sling and any other accessories if applicable.
INSTALLATION AND REMOVAL OF SOPMOD BUTTSTOCK
• Removing Buttstock from Extension Tube
• Grasp the release lever (Figure 12 (5)) on the checkered end. While pulling the release lever away
from the buttstock, slide the buttstock (Figure 12 (3)) off the end of the extension tube (Figure 2 (2)).
• Removing Battery Tubes from Buttstock
o After removing the buttstock from the extension tube, grasp the battery tube cap (Figure 12 (8))
and turn towards the opening. When the cap (Figure 12 (10)) clears the opening, pull the battery
tube (Figure 12 (8)) from the buttstock. ***Note, the flat sides that run the length of the battery
tubes are positioned towards the center of the buttstock against the flat in the tube compartment.
Ensure while replacing the tubes that the caps are fully rotated into the slot and the flats are
against their mating flat surface.
• Removing End Plate from Buttstock
o Grasp both tabs simultaneously on the end plate (Figure 12 (4)). Apply inward force to both tabs
while pulling the end plate away from the buttstock.