Manual

Rev F www.lmtdefense.com Page
13
• Rotate safety to the “SAFE” position if possible. (If hammer is not cocked, safety cannot be rotated to
“SAFE”.)
• Remove magazine by pushing in magazine catch button while pulling magazine from receiver.
• Pull charging handle fully to the rear and lock bolt to the rear by pressing on the lower portion of the
bolt catch. If not done so already place safety on “SAFE”.
• Inspect chamber and inside of receiver areas for cartridge or brass. Remove any round and other
debris. Let the bolt go forward and close the dust cover.
PREPARATION FOR FIRING
THE FAILURE TO FOLLOW FIREARM SAFETY REQUIREMENTS WILL CAUSE
SERIOUS PERSONAL INJURY OR DEATH TO YOU OR OTHERS. ALWAYS TREAT ALL FIREARMS AS IF
THEY WERE LOADED. ALWAYS BE SURE THAT THE ACTION OF FIREARMS ARE OPEN, THAT
CHAMBERS ARE CLEAR OF CARTRIDGES, MAGAZINES ARE REMOVED, AND THAT FIREARMS ARE
POINTING IN A SAFE DIRECTION.
ALWAYS WEAR ADEQUATE AND PROPER EAR PROTECTORS SPECIFIED FOR FIREARM USE
TO PREVENT PERMANENT DAMAGE TO YOUR HEARING. Make sure others who are nearby are wearing
ear protection as well.