Installation Guide

How to Install Stock Metal Blinds

Before you begin your installation:

READ ALL INSTALLATION INSTRUCTIONS!

IMPORTANT: If bound, do not remove binding until the blinds are installed in the window.

• Make sure that you have all tools and hardware needed for installation.

• Check the installation surface (wall, ceiling, or window frame) to ensure that you have suitable fasteners and tools for the material.

• Double check the headrail and blinds for proper width and length. If you are installing several sets of blinds, be sure to match them

with the appropriate window.

• Check the parts list shipped with the product to confirm that you have the correct number of brackets.

PARTS LIST

TOOLS YOU MAY NEED (NOT INCLUDED):

• Tape Measure

• Pencil

• Flat-blade or Philips Head Screwdriver

• Drill with 1/16" Bit

2. UNPACKING THE PARTS

Remove these parts packed in the headrail. Quantity varies with blind size.

Width Up to 37 in. 37 in. to 72 in.

A. Mounting Bracket 2 3

B. Bottomrail Endcap 2 2

C. Headrail Endcap 2 2

D. Hold-down Bracket 2 2

E. #5 Screw x 3/4 in. 4 4

F. #6 Screw x 1-1/4 in. 5 7

PAGE 1
How to Install Stock Metal Blinds Before you begin your installation: READ ALL INSTALLATION INSTRUCTIONS! IMPORTANT: If bound, do not remove binding until the blinds are installed in the window. • Make sure that you have all tools and hardware needed for installation. • Check the installation surface (wall, ceiling, or window frame) to ensure that you have suitable fasteners and tools for the material. • Double check the headrail and blinds for proper width and length.
PAGE 2
3. BRACKET PLACEMENT Pre-drill wood frame if necessary Inside Mount Outside Mount 4. ENDCAPS AND WAND Snap together where applicable. 5. FINISHING UP Tilt slats downward for maximum closure.