Use and Care Manual

15
Resetting the Check
Filter Indicator
Reset the Check Filter Indicator when:
A. lights up red.
1. Replace the filter (see page 16).
2. Turn on the air purifier.
3. Press and hold the button for 3
seconds.
4. will turn o when successfully
reset.
B. The filter was changed before
lit up.
1. Press and hold the button for 3
seconds.
2. The will flash for 3 seconds.
3. will turn o when successfully
reset.
CARE & MAINTENANCE
will light up as a reminder to check the
filter. Depending on how often you use the air
purifier, the indicator should turn on at about
12 months. You may not need to change your
filter yet, but you should check it when
turns on.
When your air purifier is set up with the
VeSync app, you can also check the app to
see your remaining filter life. You will also
receive a notification from VeSync when it’s
time to check your filter.
The VeSync app uses a scientific algorithm to
determine your filter life based on air quality,
amount of use, and other factors. The filter
life percentage is based on 12 hours of daily
use.
Check Filter Indicator
Cleaning the Smart Air Purifier
• Unplug before cleaning.
• Wipe the outside of the air purifier with
a soft, dry cloth. If necessary, wipe
the housing with a damp cloth, then
immediately dry.
• Vacuum the inside of the air purifier.
• Do not clean with abrasive chemicals or
flammable cleaning agents.
Filter When to Clean How to Clean When to Replace
Pre-Filter
Every 2–4
weeks
Use a soft brush or
vacuum hose
12 months
True HEPA
& Activated
Carbon Filter
Do not clean
The outer pre-filter should be cleaned every
2–4 weeks to increase eciency and extend
the life of your filter. Clean the pre-filter using
a soft brush or vacuum hose to remove hair,
dust, and large particles. Do not clean the
filter with water or other liquids.
Cleaning the Filter