Owner Manual

7
USING YOUR 2IN1 HUMIDIFIER & DIFFUSER
Note:
• If there is no water in the tank, the
humidifier will not turn on and will
blink. Fill the water tank (see Getting
Started, page 6).
• Keep the humidifier stable while using, or
water may spill.
1. Press once. The humidifier will start
on the low mist level.
2. Press several times to cycle through
mist levels (low, medium, high) and to
turn the humidifier o.
Mist Level
Intelligent Sleep Mode turns o all display
lights and uses a humidity sensor to
automatically adjust the mist level to
maintain a 60% relative humidity (RH) while
you sleep.
1. Press to turn on the humidifier.
Intelligent Sleep Mode
Note: The humidifier must be on to start
Sleep Mode.
2. Press to start Sleep Mode. After 5
seconds, all display lights will turn o.
3. Press a second time (or press )
to cancel Sleep Mode. The humidifier
will go back to the previously set mist
level.
Note:
• Excessive humidity can cause health
issues and mold growth. If the relative
humidity in your room is over 60%,
use the low mist setting or turn o
the humidifier.
• Do not pour water directly into the
base. This can cause the humidifier to
produce little to no mist. [Figure 2.1]
• Moving or shaking the humidifier can
cause too much water to flow into the
base. If the base has too much water,
pour some out.
Figure 2.1