Owner Manual

6
GETTING STARTED
1. Place the humidifier on a level, elevated,
and water-resistant surface, such as a
table or nightstand.
2. Take the water tank o of the base and
remove all tape.
3. Remove the top cover from the
water tank. Fill the tank with at least
2 cups / 475 mL of cold or room
temperature filtered water.
Figure 1.1
Note: Keep mist away from walls, furniture,
and appliances to prevent them from
getting wet.
Note:
• Only use filtered water in the
humidifier.
• Do not use hot water.
• Do not fill above the “MAX” line.
[Figure 1.1] Overfilling can cause
spilling and risk of electric shock.
• Do not add water through the mist
tube. This will damage the humidifier.
• When pouring water, never let water
get inside the air outlet (see Getting
to Know Your 2-in-1 Humidifier &
Diuser, page 5).
• If water gets inside the air outlet,
unplug the humidifier and pour out all
water. Let the humidifier rest in a well-
ventilated area for 24 hours. Do not
use again until completely dry.
Figure 1.2
MAX Line
4. Optionally, add 4–6 drops of essential
oil into the water tank.
Note: Only add essential oils into the
water tank. Do not add essential oils into
the base.
5. Make sure the tank is properly placed
on the base by aligning the indicator
marks [Figure 1.2]. Place the top cover
back onto the water tank.
6. Plug in. The humidifier will enter
standby mode.