Instruction Manual

You can help protect the environment. Please remember to respect the local regulations: hand in the non-working electrical equipment to an
appropriate waste disposal centre. The packaging material is recyclable. Dispose of the packaging in an environmentally friendly manner and make it
available for the recyclable material collection service.
Detection Range
120°
JCC Lighting Products Ltd. Innovation Centre, Beeding Close, Southern Cross Trading Estate, Bognor Regis, West Sussex, PO22 9TS, United Kingdom
Technical Support: [phone] Customer Services: [phone]
BS EN ISO9001 - 2015 - Registered Firm Certificate No. GB 1552
company
a
Installation instructions
Warnings & Cautions
• Do not install in areas that are exposed to continual running water.
• Ensure that the mounting surface is both at and stable.
• Any broken or damaged parts should be replaced as soon as possible.
• JCC will not accept responsibility for claims arising from sub-standard installations.
• These products are suitable for outdoor use only.
• This product is battery powered and they are charged via the solar panel.
• The batteries in this product are rechargeable and must only be replaced by a competant person.
INSTALLATION
ENGLISH
Square Solar Bollard
V3_February_2022_RS
Important warranty information
This product is supported by a 2-year standard warranty which will extend to 3 years if registered within the first year of purc
hase.
(2 year on batteries). Please register at jcc.co.uk/warranty - Terms and conditions apply.
The installer will be asked to provide the following information, which is detailed on a label attached to the luminaire’s chas
sis:
Product Code/Date Code.
RoHS
Compliant
IP54
jcc.co.uk
Specications Colour temp: 3000K Ra: 85 (Class III Solar light)
Prior to use, ensure that the product is fully charged
Product
code
Wattage
Lumens Solar
Charging
Time
Maximum
run time
Full power
Maximum
run time
15% power
JC17070 2W 250 6-8hrs 2.5-3 hrs
<30hrs
Fig.1.c
Non-replaceable light source
LED
LED
Fig.1.
Fig.2. Fig.2.a
Fig.1.a.
Fig.2.b. Fig.2.c.
Installation of mounting Spike:
Fit mounting spike to the base of the Solar light using
the screws supplied as illustrated in Fig.1.
Select a suitable at and stable location to insert the
spike into the earth(g.1.a.). Apply even rm pressure
to the top corners with your hands. Do not use a
hammer or weighted object to force the spike into the ground.
This will damage the product and the solar panel. Ensure the
sensor is facing the direction of travel (Fig.3.)
Installation of Base plate:
Remove base plate from the Solar light as illustrated in Fig.2.
1. Select a suitable at and stable location, and use the base plate
as a template, drill holes suitable for xings(supplied) (g.2.a.). Ret
the Solar light to the base plate and secure with the 4 screws as
shown in(g.2.b.). Ensure the sensor is facing the direction of travel
(Fig.3.)Ret body to base(g.2.c.)
2.Once installed, turn on by pressing the Touch Button for 3
seconds, the blue light will come on, allow the batteries to charge
for 6-8hrs in full sunlight.
When the light level is less the 20 Lux the light will come on and
dim to 15%, as soon as the sensor detects movement it will
increase to full power.
General Maintenance Requirements
JCC Lighting Products recommends that the this product is cleaned with
warm water and dried with a chamois leather of absorbent dry cloth.
Weathering, environmental pollution and birddroppings should be cleaned
off with a non-abrasive cleaner. This is to ensure that the solar panel is fully
effective in charging the batteries, and to preserve the nish of this product.