Specification

SAT-10092
Leviton Manufacturing Co., Inc. Global Headquarters
201 N. Service Rd. Melville, NY 11747-3138 Tech Line: 1-800-824-3005 Fax: [phone]
Leviton Manufacturing Co., Inc. Energy Management, Controls and Automation.
4330 Michoud Blvd., New Orleans, LA, 70129 Tel: [phone] Fax: [phone]
Visit our Website at: www.leviton.com/emca
©2016 Leviton Manufacturing Co., Inc. All rights reserved. Subject to change without notice.
SGI65 In-Wall Speakers Powered by Spec-Grade
®
PRODUCT DATA
• Power Handling: 120W peak/60W RMS
• Impedance: Nominal 8 Ohms/
• Minimum 6 Ohms
• Physical Dimensions and Weight:
• Height: 12.31 in/312.8 mm
• Width: 9.02 in/229 mm
• Depth: 3.20 in/81.28 mm
• Weight: 7.3 lbs
PRE-CONSTRUCTION BRACKET KIT
Cat. No.: PCI65
INSTALLATION INSTRUCTIONS
CAUTION: NOTE THAT THIS MANUAL IS WRITTEN WITH
THE ASSUMPTION THAT THE INSTALLER POSSESSES
SKILL IN THE PROPER USE OF HAND AND POWER
TOOLS, AND IS FAMILIAR WITH THE ENVIRONMENT
BEHIND THE SURFACE OF THE WALL OR CEILING
WHERE THE SPEAKERS WILL BE INSTALLED.
TO INSTALL:
1. Select speaker mounting location. Route speaker
cable from source to this location. Note: We
recommend the use of 16/2 (minimum) class 3
speaker wires.
2. Attach wings to back plate of Pre-Construction
Bracket (refer to Figure 1A). Only two wings are
required for each back plate. Select the mounting
arrangement that best suites your specific
application. Note: The wings are designed to be
shortened as required.
3. Attach the Pre-Construction Bracket in the desired
location to the underside of framing members so that
after drywall installation, the bracket and the wings
are sandwiched between the drywall and the framing
member (ensure “FRONT” is facing into the room) (refer
to Figure 1A). If the mounting area is too congested to
use both mounting wings you can drive screws through
the back plate directly into the framing member.
4. Loop the speaker wire and attach it to the wire
management loops on the back of the bracket.
5. After drywall installation install speakers in holes
provided by drywall installer. Follow instructions included
in speaker packaging.
ORDERING INFORMATION
DESCRIPTION CAT. NO.
Pair of 6.5” Spec-Grade Two-Way In-Wall Loudspeakers, 120 W peak/ 60 W RMS, 8 ohms SGI65-00W
Rough-in Bracket for 6.5” In-Wall Loudspeakers PCI65-KIT
Figure 1A – In-Wall Mounting