Installation Guide

ManualsBrandsLeviton ManualsElectricalDecora Passive Infrared Occupancy Sensor with LED Adjustable Night Light, Ivory

OPERATION

PUSH-BUTTON:Cat.No.OSSNL/OSSNL-INx/OSS10-IDxhasa

push-button switch that toggles the lights (refer to gure).Ifthe

lightsareOFF,thelightswillturnONwhenthebuttonispressed,and

remainONinthepresenceofmotion.Intheabsenceofmotion,the

SensorUnitwilltime-outandturnthelightsOFF.

IfthelightsareON,thelightswillturnOFFwhenthebuttonispressed.

ThelightswillstayOFFregardlessofmotiondetected,untilthetime-

outexpires.Afterthetime-outexpires,thelightswillturnON(Auto-ON

Modeonly)withthenextdetectedmotion.Thisisusefulforslideor

lmpresentations.

NOTES:

• TheMotionIndicatorLEDwillblinkevery2secondswhilemotionis

detected.

• InManual-ONmode,thebuttonmustbepressedtoturnthe

lightsON.

PRODUCT INFORMATION

• Fortechnicalassistancecontactusat1-800-824-3005

• Visitourwebsiteatwww.leviton.com

PK-93369-10-00-0B

Field-of-View (Horizontal)

20 ft (6.1 m)

small motion

30 ft (9.1 m)

20 ft (6.1 m)

small motion

40 ft

(12.2 m)

Side (Vertical) Field-of-View

27 ft.

(8.2 m)

38 ft.

(11.7 m)

4 ft.

(1.2 m)

4.5 ft.

(1.4 m)

8.3

Sensor Unit

• Securedevicebyrmlytighteningmountingscrews.

• InstallDecora

stylewallplate(soldseparately).

Sensor and Wallplate Mounting:

Step 7

Wall surface

Device mounting screw

(2 places)

Wallplate

mounting

screw

(2 places)

Sensor Features Diagram

Lens with

PIR and LED

NightLight

Blinders

Control Panel

Cover

Push Button

LED

Indicator

Step 6 cont’d

Testing your Sensor prior to

completely mounting in wall box:

FEATURES AND SETTINGS:

TIME-DELAY:Cat.No.OSSNL/OSSNL-INx/OSS10-IDxwillturn

lightsONwhenmotionisdetected.Whenmotionisnolonger

detected,theSensorUnitwillwaitacertainamountoftimeand

thenturnthelightsOFF.Thiswaittimeiscalled‘time-out’.

The“time-out”isselectedfromfour(4)presetvalues.Pointingthe

arrowatoneofthemarkingsonthefacechoosesthevalueoftime.

ThebuttonLEDindicatorlightwillashtwicewhenthetimesetting

haschanged.Thefollowingselectionsareavailable:

OSSNL-IDx: Face Marking Value of Time

NOTE:The“time-out”isfactorypresettothirty(30)minutes

(refer to Sensor Features Diagram).

NOTE: All time durations mentioned in the instructions are

approximatewithin10seconds.

OSS10-IDx: Face Marking Value of Time

NOTE: The“time-out”isfactorypresettoten(10)minutes

(refer to Sensor Features Diagram).

NOTE: All time durations mentioned in the instructions are

approximatewithin10seconds.

RANGE:Todecreasedetectionrangeandsensitivity,rotatethe

knobcounter-clockwise(refer to Sensor Features Diagram).The

detectionsrangecanbeadjustedfrom100%downto35%.

MANUAL-ON MODE (OSSNL-INx ONLY):Thefactorydefault

settingfortheOSSNLisManual-ON.Tochangethissettingto

Auto-ON/OFF,turnthedialmarked“ONMODE/NLDIM”clockwise

anywhereintotheareathatindicates“AUTO”.Toreturnto

Manual-ON,turnthedialcounter-clockwiseanywhereintothearea

thatindicates“MAN”.

NOTE:OSS10isaManual-ONsettingonly.

NIGHTLIGHT:TheOSSNL/OSSNL-INx/OSS10-IDxrespondsto

theambientlightlevelpresentinaroom.TheOSSNL/OSSNL-INx/

OSS10-IDxusesaninternalphotocelltodetectwhentheambient

lightlevelisapproximatelylessthan1footcandleactivatingthe

LEDNightLight.Further,theinternalphotocellwillturnOFFthe

LEDNightLightwhenitdetectsanambientlightlevelover5foot

candles.TheLEDNightLighthasadjustablelightoutputtomeetthe

needs of the space and can be set to for continuous mode or dim

modewhichwillautomaticallydimto5%offullbrightnessafter2

minutesofnooccupancy.

NIGHTLIGHT DIM:ToadjusttheLEDNightLightoutput,turnthe

dialmarked“ONMODE/NLDIM”(OSSNL-INx)or“NITELITEDIM”

(OSS10)counter-clockwisetodecreaseandclockwisetoincrease

lightoutput.

NIGHTLIGHT MODE:Thefactorydefaultsettingforthe

NightLightModeisdimmedmode.ThismeanstheLEDNightLight

automaticallydimsto5%offullbrightnessafter2minutesofno

occupancywhenactivatedbytheinternalphotocell.Tochangethe

NightLightModeperformthefollowingprocedure:

1. Press and hold the push button for 2 seconds to determine the

currentmode.

a. NightLightashesonceevery1secondforContinuousMode

untilthebuttonisreleased.

b. NightLightashestwiceevery1secondforDimModeuntil

thebuttonisreleased.

2.Tochange,holdthepushbuttonfor10secondsandtheMode

willtoggle.Thiswillbeindicatedbyachangeintheashpattern

asdescribedabove.

TROUBLESHOOTING

1.Ifthereisnoresponsefromtheunit(thelightneverturnsONand

theLEDneverblinks)11/2minutesafterpowerisapplied,then

uninstalldeviceandverifythereisagroundconnectionatthe

wallbox.Ifthereisagroundconnection,verifywiring.

2.IfthelightsneverturnON,buttheLEDblinks,checkifthe

Manual-ONsetting(OSSNLonly).SeeManual-ONModesettingfor

adjustments.

3.IfthelightsconstantlystayON,evenwhentheroomisunoccupied:

A.ChecktheTimesetting.Seehowthistimecomparestohow

longthelightsstayON.

B.TryloweringtheRangeControl.Rotatetheknobcounter-

clockwiseabout30°.

C.Iftheproblempersists,tryreducingagain.

NOTE:DoNotreducesomuchthatCat.Nos.

OSSNL/OSSNL-INx/OSS10-IDxcannotseenormaloccupancy.

D.BesuretousetheBlinderstoblockanyunwanted

hallwaytrafc.

E.Checkforreectedheat/motionasSensorUnitmaybeseeing

motionthroughawindow.

F. CheckforadjacentHVACand/orheaterducts.

NOTES

Cat. No. OSSNL

T IM E

ON MODE/NL DIM

MAN

AUTO

RANGE

Blinder adjustment levers

BLINDERS

Control Panel Cover

30M

30S

Cat. No. OSS10

TIME

NITELITE DIM

MIN MAX

Blinder adjustment levers

BLINDERS

Control Panel Cover

10M

30S

20M

30M

RANGE

30S

30M

30secondxedtime-outforperformingawalktest

30 minute time-out

1 hour time-out

2 hour time-out

Value of TimeFace Marking

30S

10M

20M

30M

30secondxedtime-outforperformingawalktest

10 minute time-out

20 minute time-out

30 minute time-out

Value of TimeFace Marking

FCC COMPLIANCE STATEMENT

ThisdevicecomplieswithPart15oftheFCCRules.Operationis

subjecttofollowingtwoconditions:(1)thisdevicemaynotcause

harmfulinterference,and(2)thisdevicemustacceptanyinterference

received,includinginterferencethatmaycauseundesiredoperationof

thedevice.

Thisequipmenthasbeentestedandfoundtocomplywiththelimits

foraClassBDigitalDevice,pursuanttoPart15oftheFCCRules.

Theselimitsaredesignedtoprovidereasonableprotectionagainst

harmfulinterferenceinaresidentialinstallation.Thisequipment

generates,uses,andcanradiateradiofrequencyenergyand,ifnot

installedandusedinaccordancewiththeinstructions,maycause

harmfulinterferencetoradiocommunications.However,thereisno

guaranteethatinterferencewillnotoccurinaparticularinstallation.If

this equipment does cause harmful interference to radio or television

reception,whichcanbedeterminedbyturningtheequipmentOFFand

ON,theuserisencouragedtotrytocorrecttheinterferencebyoneor

moreofthefollowingmeasures:

• ReorientorrelocatethereceivingAntenna.

• Increasetheseparationbetweentheequipmentandthereceiver.

• Connecttheequipmentintoanoutletonacircuitdifferentfromthat

towhichthereceiverisconnected.

• Consultthedealeroranexperiencedradio/tvtechnicianforhelp.

FCC CAUTION

AnychangesormodicationsnotexpresslyapprovedbyLeviton

ManufacturingCo.,Inc.,couldvoidtheuser'sauthoritytooperatethe

equipment.

LIMITED 5 YEAR WARRANTY AND EXCLUSIONS

LevitonwarrantstotheoriginalconsumerpurchaserandnotforthebenefitofanyoneelsethatthisproductatthetimeofitssalebyLevitonisfreeofdefectsinmaterialsandworkmanshipundernormalandproperuseforfiveyearsfromthepurchasedate.Leviton’sonlyobligationistocorrectsuchdefectsbyrepairorreplacement,atitsoption,ifwithinsuchfiveyearperiodtheproductisreturnedprepaid,with

proof of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att: Quality Assurance Department, 201 North Service Road, Melville, New York 11747.Thiswarrantyexcludesandthereisdisclaimedliabilityforlaborforremovalofthisproductorreinstallation.Thiswarrantyisvoidifthisproductisinstalledimproperlyorinanimproperenvironment,overloaded,misused,opened,

abused,oralteredinanymanner,orisnotusedundernormaloperatingconditionsornotinaccordancewithanylabelsorinstructions.There are no other or implied warranties of any kind, including merchantability and fitness for a particular purpose,butifanyimpliedwarrantyisrequiredbytheapplicablejurisdiction,thedurationofanysuchimpliedwarranty,includingmerchantabilityandfitnessfora

particularpurpose,islimitedtofiveyears.Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay or failure to perform this warranty obligation.Theremediesprovidedhereinaretheexclusiveremediesunderthiswarranty,whetherbasedoncontract,tortorotherwise.