Specification

Leviton Manufacturing Co., Inc. Global Headquarters
201 N. Service Rd. Melville, NY 11747-3138 Tech Line: 1-800-824-3005 Fax: [phone]
Leviton Manufacturing Co., Inc. Energy Management, Controls and Automation.
4330 Michoud Blvd., New Orleans, LA, 70129 Tel: [phone] Fax: [phone]
Visit our Website at: www.leviton.com/emca
©2016 Leviton Manufacturing Co., Inc. All rights reserved. Subject to change without notice.
ORDERING INFORMATION
DESCRIPTION Part #
Leviton Architectural Edition In-Wall Center Channel Loudspeaker Powered by JBL® LAE5I-000
In-Wall Center Shelf Preconstruction Kit (for use with LAE5I) AEPIS-KIT
SAT-10103
REV SEP 2016
Leviton Architectural Edition In-Wall Center Channel Loudspeaker Powered by JBL®
PRODUCT DATA
AEPIS-KIT INSTALLATION INSTRUCTIONS
1. To accommodate correct speaker orientation, the
AEPIS-KIT can be installed horizontally or vertically.
For vertical installation, the snap on wings (a)
must be used (see Fig. 1). In horizontal installation,
if cross braces are available above & below the
speaker location, the snap on wings (a) can be
used (see Fig. 2), or the rough-in-frame tabs (see
(b) in Fig. 4) can be directly nailed onto vertical wall
studs (see Fig. 3).
2. When using installation methods shown in
Fig. 1 or Fig. 2, snap the two flat wing sections
(a) onto the rough-inframe. Note: Use the edge
of the wing with the set of two large rectangular
openings (see (e) in Fig. 4).
3. Position the rough-in-frame assembly as required
between the wall studs or cross braces and nail
into place. Be sure that the nail heads are set as
flush as possible against the snap-on wings or the
rough-inframe tabs (see (b) in Fig. 4). Note: Wire
tabs (see (c) in
Fig. 4 or Fig. 5) go towards the back (inside
of the wall).
4. Fig. 5. Pre-routed wire can be held in place using
the molded wire tabs (c) on the back side of the
frame unit. Be sure that no wire remains exposed
on the front (wall board) side of the assembly.
Please note that in order to facilitate correct
wall board installation, the raised inner lip of the
rough-in-frame (d) serves as a physical barrier
that the wall board edge should rest against.
After wallboard installation is complete, the
speaker wire can be run through the opening in the
wallboard and attached to the speaker system as
detailed in the owner’s manual.