Cut Sheet

IllumaTech
IllumaTech™ Preset Slide Controls —
Single Pole and 3-Way, with LED Locator
All IllumaTech Preset Dimmers provide single-pole (one location) and 3-way (multi-location) control when used with a 3-way switch.
DESCRIPTION CAT. NO. RATING COLOR CHANGE KIT*
IllumaTech Incandescent IPI06-1LW 600W 120V AC 60 Hz W, I, A, G, E, B
IllumaTech Incandescent (no LED locator) IPI06-10W 600W 120VAC 60 Hz W, I, A, G, E, B
IllumaTech Incandescent IPI10-1LW 1000W 120VAC 60 Hz W, I, A, G, E, B
IllumaTech Electronic Low-Voltage IPE04-1LW 400VA (300W) 120V AC 60 Hz W, I, A, G, E, B
IllumaTech Magnetic Low-Voltage IPM06-1LW 600VA (450W) 120V AC 60 Hz W, I, A, G, E,B
IllumaTech Magnetic Low-Voltage IPM10-1LW 1000VA (750W) 120V AC 60 Hz W, I, A, G, E, B
IllumaTech Advance Mark X
™
IPX06-1LW 600VA (450W) 120V AC 60 Hz W, I, A, G, E, B
Fluorescent Dimming Ballast
IllumaTech Advance Mark X
™
IPX10-1LW 1000VA (750W) 120V AC 60 Hz W, I, A, G, E, B
Fluorescent Dimming Ballast
IllumaTech Advance Mark X
™
IPX06-7LW 600VA (450W) 277V AC 60 Hz W, I, A, G, E, B
Fluorescent Dimming Ballast
IllumaTech Advance Mark X
™
IPX12-7LW 1200VA (900W) 277V AC 60Hz W, I, A, G, E, B
Fluorescent Dimming Ballast
IllumaTech Advance Mark VII IP710-DLW 1200VA (900W) 120V AC 60Hz; W, I, A, G, E, B
0-10V and OSRAM Sylvania Quicksonic Helios 1500VA (1200W) 277V AC 60Hz
Fluorescent Dimming Ballast
IllumaTech Quiet Fan Speed Control IPF01-1LW 1.5 Amps 120V AC 60 Hz W, I, A, G, E, B
IllumaTech Fan Speed Control IPF05-1LW 5 Amps 120V AC 60 Hz W, I, A, G, E, B
IllumaTech Color Change Kit IPKIT-00W — W, I, A, G, E, B
IllumaTech Color Change Kit IPQFK-00W — W, I, A, G, E, B
for Quiet Fan Speed Control
Available in Ivory (-I), White (-W) and Almond (-A) for the retail market; White (-W) only for distributors. For other colors, order Color
Change Kits and add suffix as follows: Ivory (-I), White (-W), Almond (-A), Gray (-G), Black (-E), and Brown (-B).
Leviton Mfg. Co., Inc. 59-25 Little Neck Pkwy • Little Neck, NY 11362 • Phone: [phone] • Fax: [phone]
JOB NAME:
JOB NUMBER:
CATALOG NUMBERS:
SPECIFICATION SUBMITTAL
Visit our Website at: www.leviton.com
Performance Specifications
Electrical • Input 120 VAC @ 60Hz., 277 VAC @ 60Hz. • Line voltage regulation. • RFI noise suppression.
Mechanical • Dimmer control – slide with a travel of 20mm. • Push on/off switch control.
• Three wire device plus ground wire, dual-rated model is five wire device plus ground wire.
• The LED will be lighted when the load off. • Separate air-gap switch is not needed.
Environmental • Operating 0 degrees celsius to 55 degrees celsius • Non-operating –10 degrees celsius to 85 degrees celsius
• Relative humidity, non-condensing 20% to 90%
Note: Sharing a neutral wire may cause flickering. Connect all dimmers to the same phase or run a separate neutral to each phase. Consult Leviton Techline if
problems persist.
CAUTION ON RETROFITS: When retrofitting Mark X dimming ballasts into fixtures that originally had Instant Start ballasts, the sockets MUST be replaced with Rapid
Start sockets to allow proper dimmer operation and prevent damage to the dimming ballast. Refer to the instructions provided with the ballast and the Leviton Mark
X dimmer.
G-6444/G2/eg