Specification

IllumaTech
®
Preset Slide and Rotary Controls
AGENCY STANDARDS AND COMPLIANCE
n UL Listed (File #E-31373)
n CSA Certified (File #LR-3413)
IllumaTech Preset Slide Controls
IllumaTech Dual Controls IllumaTech Rotary Controls
Color Change Kit for IllumaTech Slide Controls
(Preset Kit Shown)
Leviton Mfg. Co., Inc.
201 North Service Road, Melville, NY 11747 Tech Line: 1-800-824-3005 Fax: [phone] www.leviton.com
© 2014 Leviton Manufacturing Co., Inc. All rights reserved. Subject to change without notice.
Note: Sharing a neutral wire may cause flickering. Connect all
devices to the same phase or run a separate neutral to each
phase. Consult Leviton Techline if problems persist.
Warning: When retrofitting Mark 10
®
Powerline dimming
ballasts into fixtures that originally had Instant Start ballasts,
the sockets MUST be replaced with Rapid Start sockets
to allow proper dimmer operation and prevent property
damage, injury or death. Refer to the instructions
provided with the ballast and the Leviton dimmer.
INSTALLATION CONSIDERATIONS
Frame
Strap
Snaps
Push in 2
Locations
ON/OFF
LED
Slider
DIMENSIONAL DRAWINGS
IPL06: LED and CFL lamps marked or rated as dimmable can be
used with this dimmer. For a complete list of approved LED and
CFL lamps visit www.leviton.com/universal
O
F
F
M
A
X
H
I
M
E
D
L
O
3.28
(83.34)
2.67
(67.81)
4.12
(104.64)
1.73
(44.04)
2.12 (53.8)
1.41
(35.8)
0.38 (9.7)
2.68 (68.1)
3.28 (83.3)
4.15 (105.4)
0.75
(19.05)
1.30
(33.12)
3.28
(83.34)
2.23
(56.64)
4.12
(104.64)
1.73
(44.04)
0.75
(19.05)
1.30
(33.12)
O
F
F
M
A
X
H
I
M
E
D
L
O
3.28
(83.34)
2.67
(67.81)
4.12
(104.64)
1.73
(44.04)
2.12 (53.8)
1.41
(35.8)
0.38 (9.7)
2.68 (68.1)
3.28 (83.3)
4.15 (105.4)
0.75
(19.05)
1.30
(33.12)
3.28
(83.34)
2.23
(56.64)
4.12
(104.64)
1.73
(44.04)
0.75
(19.05)
1.30
(33.12)
O
F
F
M
A
X
H
I
M
E
D
L
O
3.28
(83.34)
2.67
(67.81)
4.12
(104.64)
1.73
(44.04)
2.12 (53.8)
1.41
(35.8)
0.38 (9.7)
2.68 (68.1)
3.28 (83.3)
4.15 (105.4)
0.75
(19.05)
1.30
(33.12)
3.28
(83.34)
2.23
(56.64)
4.12
(104.64)
1.73
(44.04)
0.75
(19.05)
1.30
(33.12)
Use Leviton Power Extenders to extend the load capacity of box mounted
dimmers. Leviton Power Extenders are available for incandescent, magnetic
low voltage, electronic low voltage, Mark 10
®
Powerline fluorescent dimming
ballasts or equivalents and 0-10 VDC dimmable fluorescent ballasts such as
Mark 7
®
0-10V, OSRAM Sylvania Quicktronic
®
Helios™ or equivalent ballasts.
– CFL mode for dimmable CFLs. This feature
provides a higher starting voltage that is
required for many Compact Fluorescent Lamps.
– LED/Incandescent mode provides optimized
dimming for LED lamps and for incandescent
operation.
– Switch also enables the programming mode
allowing users to change the dimmer low
light settings for applications where the user
experiences unstable light or flicker.
Lamp Selector/
Programming
Switch