Installation Manual

evr-green
™
Level 1 / Level 2 Combination
Network Charging Station For Public Applications
lll#aZk^idc#Xdb$Zkg\gZZc&"-,,"((-",),(Zkg\gZZc5aZk^idc#Xdb
3-7
Step 6 - Connect wires to wiring terminals
Ejaai]Z')%KA'WajZVcYA&gZYVcYi]Z
&'%KA^cZWaVX`!CZjigVal]^iZ!VcY<gdjcY
(green) wires into body assembly and connect
to wiring terminals.
Hig^el^gZhÇ+bb!^chZgi^ciZgb^cVaWadX`!
VcYi^\]iZchXgZlhid&-#*^cX]"aWh'#&Cb#
IMPORTANT:
GZfj^gZhVYZY^XViZY'%6WgZV`Zg[dg&'%K
VcY)%6WgZV`Zg[dg'%-$')%K#
JhZXdeeZgXdcYjXidghdcan#
9dCDIegdk^YZ<;8>egdiZXi^dcVieVcZa#
I]Z:kg"<gZZcAZkZa&$AZkZa'8dbW^cVi^dc
EjWa^XJhZHiVi^dc]VhWj^ai"^c<;8>egdiZXi^dc#
>cVgZVhl^i][gZfjZcii]jcYZghidgbh!VYY
surge protection at the service panel for
all circuits.
TIP:
IdbV`Z^iZVh^ZgidXdccZXii]Z
wires,you can remove and replace the
terminal block. To do so, simply loosen
the two mounting screws holding the
terminal block to the body a few turns
Then slide the terminal block up and off
the screws. Insert the wires and tighten
the wiring screws as described above.
Then, slide the terminal block back over
its two mounting screws, and tighten the
mounting screws.
You have now finished installing the
EdaZBdjci^c\VhhZbWan[dgi]Z:kg"<gZZc
AZkZa&$AZkZa'8dbW^cVi^dcEjWa^XJhZHiVi^dc#
You are ready to install the holster and cable
VhhZbWan#HZZ8]VeiZg*#
JhZi]ZhZ
*hXgZlh
For use in EVR-Green Level 1/Level 2
Combination Station
Input: 120 VAC, 60 Hz, 16 A
208/240 VAC, 60 Hz, 30 A
Use copper conductors only.
Input terminal recommended tightening torque:
18.5 In.-lbs. (2.1 Nm)
Input terminal wire size range:
6 to 12 AWG (13mm
2
to 3mm
2
solid / stranded