Installation Manual

evr-green
™
Level 1 / Level 2 Combination
Network Charging Station For Public Applications
lll#aZk^idc#Xdb$Zkg\gZZc&"-,,"((-",),(Zkg\gZZc5aZk^idc#Xdb
Step 7 - Connect wires to wiring terminals
Ejaai]Z')%KA'WajZVcYA&gZY
VcYi]Z&'%KA^cZWaVX`!CZjigVa
l]^iZ!VcY<gdjcY\gZZcl^gZh^cid
body assembly and connect to wiring
terminals.
Hig^el^gZhÇ+bb!^chZgi^c
terminal block, and tighten screws to
&-^cX]"aWh'#&Cb#
IMPORTANT:
GZfj^gZhYZY^XViZY'%6WgZV`Zg[dg
&'%KVcY)%6WgZV`Zg[dg'%-$')%K#
JhZXdeeZgXdcYjXidghdcan#
9dCDIegdk^YZ<;8>egdiZXi^dcVi
eVcZa#I]Z:kg"<gZZcAZkZa&$AZkZa'8dbW^cVi^dc
EjWa^XJhZ8]Vg\^c\HiVi^dc]VhWj^ai"^c
<;8>egdiZXi^dc#
>cVgZVhl^i][gZfjZcii]jcYZghidgbh!VYYhjg\Z
protection at the service panel for all circuits.
TIP: To make it easier to connect the wires, you can
remove and replace the terminal block. To do so,
simply loosen the two mounting screws holding the
terminal block to the body a few turns.
Then slide the terminal block up and off the screws.
Insert the wires and tighten the wiring screws as
described above.
Then, slide the terminal block back over its two
mounting screws, and tighten the mounting screws.
2-8
JhZi]ZhZ
*hXgZlh
For use in Evr-Green Level 1/Level 2
Combination Station
Input: 120 VAC, 60 Hz, 16 A
208/240 VAC, 60 Hz, 30 A
Use copper conductors only.
Input terminal recommended tightening torque:
18.5 In.-lbs. (2.1 Nm)
Input terminal wire size range:
6 to 12 AWG (13mm
2
to 3mm
2
solid / stranded