Cut Sheet

Component
Specifications
3880-DIN
APPLICATION
The Infrared (IR) Repeater System consists of three pieces: an IR
Target, IR Emitter and a distribution block for distributing control signals
to multiple emitters. The IR Target easily installs in the ceiling or wall,
and connects with Category 5/5e cable to the IR Emitter. A separate IR
Emitter is used for each controlled audio/video component, through
the distribution block in the Structured Media™ enclosure.
STANDARDS COMPLIANCE
Meets or exceeds all applicable standards: UL recognized components.
PHYSICAL SPECIFICATIONS
Dimensions: 2"h x 1"w
Target Output: 1 signal lead
Target Input: 2 power leads (DC + and -)
Emitter Output: Infrared to control source component
Emitter Input: 2 signal leads
Power Supply: 12VDC @ 500mA
Emitter Length: 6‘ of Cable
DESIGN CONSIDERATIONS
• Low-profile, flush-mount Target design.
• Two signal connections and two power connections.
• Emitter features adhesive surface for easy installation on
audio/video components.
• Distribution block for multiple Emitter configurations.
• DC power supply.
• Uses Category 5/5e UTP wire.
• Target has talkback LED to indicate proper operation.
WARRANTY INFORMATION
• Two-year limited product warranty.
Infrared Repeater System
Infrared Repeater System
Part Numbers
47621-MIE
47621-CMS
47603-110
2222 – 222nd St. SE • Bothell, WA 98021 USA • Tel: [phone] • Fax: [phone] • Int'l Fax: [phone] • GSA# GS-35F-1628G
For Applications Engineering Support – Call 1-425-485-4288; in USA call 1-800-722-2082
Spec sheets and updates are also available at www.levitonvoicedata.com.
See ELECTRONIC FILES for CAD files (.DXF, .DWG, MS-DOS.EPS) on disk
For ELECTRONIC Typical Specs see (.TXT) file on disk.
TYPICAL SPECIFICATIONS
The Infrared Repeater System shall contain an IR Target, IR
Emitter and a distribution block. It shall be a low profile, flush-
mount target design consisting of two signal connections and
two power connections. The Target shall have 1 output signal
lead and 2 power input leads. It shall use a12VDC at 500 mA
power supply. The Emitter shall have an adhesive surface for
component installation. The manufacturer shall provide a two-
year limited product warranty.