Installation Guide

IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
WARNINGS AND CAUTIONS:
• TO AVOID FIRE, DEATH, OR INJURY, CAREFULLY READ THE CHARGING
INSTRUCTIONS IN YOUR VEHICLE’S MANUAL BEFORE CHARGING, AND
HEED THE FOLLOWING WARNINGS:
- DO NOT use the EVSE Charging Station with a damaged AC outlet.
- DO NOT use an extension cord to provide power to the EVSE Charging Station.
- DO NOT operate the EVSE Charging Station with a visibly damaged AC Supply
Plug or Charge Cord/Connector. Inspect equipment before each use. If any
damage is detected, contact Customer Support.
- NOT FOR USE in commercial garages where a COMMERCIAL GARAGE
is defined as a facility, or portion of a facility, used for the repair of internal
combustion engine vehicles, in which the area may be classified due to vapors of
flammable liquids (gasoline) being present.
• The EVSE Charging Station is a high powered electrical device. Connect only to a
circuit provided with 30 amperes maximum branch circuit over-current protection in
accordance with the National Electrical Code, ANSI/NFPA 70.
• This device shall be mounted at a sufficient height from grade such that the height of
the storage means for the coupling device is located between 24 inches (600 mm )
and 4 feet (1.2 m) from grade.
• Ensure that the Charge Cord is positioned so it will not be stepped on, tripped
over, or otherwise subjected to damage or stress. Always stow the EVSE Charging
Station in a safe place after each use.
• Use this EVSE Charging Station to charge electric vehicles equipped with an SAE
J1772™ compliant charge port ONLY. Refer to the vehicle owner’s manual to
determine if the vehicle is equipped with an SAE J1772™ compliant charge port.
• DO NOT attempt to repair or service the EVSE Charging Station yourself. Refer to
the Troubleshooting section, or Customer Support section for service information.
• Retain this guide for future reference.
1
Level 2
Electric Vehicle Supply Equipment
Charging Station