Operation Manual

12 Babyviewer 2500
Babyviewer 2500
3.2 Baby unit
18. Night Light
19. Night Light button
20. Microphone
21. Support
22. Lens
23. Infrared LED’s
24. Power indicator LED
25. Antenna
26. On/Off switch
27. DC power adapter Jack
28. Battery cover
29. Speaker
30. Baby bed fastener
4 Getting started
4.1 Baby unit battery Installation
The camera uses either 4 AAA - Size batteries (alkaline batteries recommended) or the
household AC current. The Baby unit has no charging function.
2
1
3
1
2
3
1. Loosen the screw in a counter clockwise direction using a small screw driver. Remove
the battery cover.
2. Install 4 ‘AAA’ alkaline or rechargeable batteries following the polarity as shown. Close
the battery compartment.
3. Slide the Power switch (26) to the ON positio
n. The LED (24) on top of the camera
should light up red.
Slide the Power switch (26) to the OFF
position to turn off the baby unit.
When the light (24) is blinking, the batteries are low and need to be replaced.
Do not mix old batteries with new ones.
Keep batteries away from small children.
Do not short-circuit & dispose of in fire.
Remove the batteries if this device is not going to be used for a long period.