Operation Manual

30
Error notifications Mastermind
10.3 System errors
There can be system errors in the oven. When for
example the core probe has been damaged by placing it
between the door, the notification will appear that you
cannot use the core probe any longer. Programmes
such as Delta-T and Cook&Hold cannot be used when
this occurs.
10.4 Fatal errors
Fatal errors will occur only seldomly, but will have as an
effect that due to an internal error the oven will no longer
be able to function properly. When such a fatal error,
then follow the instructions on the screen.
Always try to restart the oven before calling Leventi
Service.
Table 6: System errors
Report in the screen What should you do
102 Core probe damaged. Only
preparation without core
probe.
You can continue to work,
however without the core
probe.
107 Boiler damaged. When this
occurs again call the
Customer Services.
You can continue to work.
When this occurs again
call the Customer Services
108 Condensor does not work
properly. When this occurs
again call the Customer
Services
You can continue to work.
When this occurs again
call the Customer Services
109 No climate control
possible. Check the water
supply. Advise do not cook.
Call the Customer Services
You can continue to work
but possibly without
humidity programmes. Call
the Customer Services
110 Valve is not functioning
properly. Call the
Customer Services
When this occurs again
call the Customer Services
111 Oven is heating too slow.
Call the Customer Services
You can continue working
but report this to the
Customer Services
117 Booster does not work Re-start oven or continue
to work without booster. If
this recurs call service.
116 Boiler is not filling. Check
the water supply. When
this occurs again call the
Customer Services
You can continue to work.
When this occurs again
call the Customer Services
120 Programme not suitable
for this oven configuration.
Choose another
programme.
This programme has been
made on another oven
configuration and is not (no
longer) feasible (for
example core probe
damaged).
123 No contact with
Boosterprint.
Re-start oven or continue
to work without booster. If
this recurs call service.
126 Incorrect configuration.
Boiler/ACS, no injection?
Degreaser, no condenser?
The configuration is set
incorrectly.
135 No cleaning material Replace Safepack
136 No polishing material Replace Safepack
137 Door opened during water
check
Close door several
seconds after pushing
start button
139 Pumping empty of boiler
unsuccessful.
Pumping empty of boiler
unsuccessful.
Check pump and drain
140 Internal error: programme
not correct
Quickest solution: delete
baking programme and re-
program.
141 Internal error: programme
not correct
Quickest solution: delete
baking programme and re-
program.
777 A system error occured.
Confirm to go to
mainmenu.
Press the green button
Table 7: Fatal errors
No Notification in the screen
103 Security overheating active. Call the Customer Services
Department.
104 Security overheating active. Call the Customer Services
Department.
105 Security overheating active. Call the Customer Services
Department.
106 Room temperature cannot be measured. When this
occurs again call the Customer Services Department.
118 Oven does not work properly. Call the Customer
Services Department.
119 Check, clean and or replace the filter.
121 Print damaged
122 Problems with the motor. When this occurs again call
the Customer Services Department.
124 No water supply. Check the water supply! Are there
chemicals in the oven? Oven needs to be turned off.
Table 6: System errors
Report in the screen What should you do