Operation Manual

Maintenance and cleaning

9.5.3 Changing the door seals

A door seal will ensure a good closure between the door

seal and the oven cavity. The door seal is subject to wear

and tear. When you replace the seal then act as follows.

Advise: poke a couple of holes in the rubber (in the back

that you use to put into the oven). This prevents the

sticking of the door seal.

• Remove the old door seal.

• Make the dent where the door seal fits in clean of

dust and any other residue such as kit.

• Then you apply a small quantity of kit in the lower

corners. Small tubes are available under article code:

05001086000.

• Start in the left upper corner. Press the corner.

Stretch the rubber out to the right above corner and

also press this.

• Then press the rubber in the two upper corners.

• Also stretch the rubber out to the left below corner

and also press this.

• Continue this operation until it fits everywhere.

• Then also press the doorseal firmly with a hard but

blunt object.

9.5.4 Reset after a power failure

You should never do this yourself. Let a specialised

service technician do this. In the switch board there are

many buttons and other parts which are under high

voltage. Wrong actions may lead to life threatening

situations.