User Manual

Help Manual

Level: Displays the intensity level of the area underneath the pointer.

Count: Shows the total number of pixels corresponding to the intensity level

underneath the pointer.

Percentile: Displays the cumulative number of pixels at or below the level

underneath the pointer. This value is expressed as a percentage of all of the pixels in

the image, from 0% at the far left to 100% at the far right.

11.7 Resolution•••

Choose this command to set the image Resolution to calibrate the spatial scale. By

default, ToupView expresses spatial measurements in terms of pixels. This

Resolution command is used to change the terms in which ToupView reports such

measurements. This command should be run first if in order to measure objects in

terms of units other than pixels.

X: Horizontal PPM (Pixels per meter) of current Resolution.

Y: Vertical PPM (Pixels per meter) of current Resolution.

Note: The resolution in the Y direction need not to be filled. ToupView will always let

it equal to the X direction.

After the new Resolution is set, all of the measurements will be calculated according

to the new Resolution. (See more in the Measurements and

Options>Measurements•••).

11.8 Overlay Scale Bar•••

Image>Overlay Scale Bar••• will overlay a scale bar on an image. The scale bar