User Manual

Help Manual
103
After the Measurement is done on the specific layer, choose this menu to select the
objects.
1. The object can be selected by clicking on it;
2. Select a group of objects by including them in a rectangular area with Object
Select command or by press down the Shift key and clicking the object with left
mouse button until all the desired objects are selected.
Note: 1) To check or modify the parameters of the selected object, just select a single
measurement object and the Measurement sidebar will be activated automatically.
Here you can edit the corresponding object parameters to modify its properties;
2) The Appearance, Coordinates on Measurement sidebar will be enabled only
when a single object is selected. The Calculation will be effective for a single selected
object or more selected objects. Its calculated items will depend on the selected
objects type (The type could be the same or could be different).
14.2 Angle
1. Move the mouse on the image to point 1, mark it by clicking the left mouse button;
2. Move the mouse to point 2, mark it by clicking the left mouse button;
3. Move the mouse to point 3, mark the final point by clicking the left mouse button.
A label A1@50.26deg will be shown near point 2;
Note: 1) To check or modify the parameters of the selected object, just select a single
measurement object and the Measurement sidebar will be activated automatically.