Operation Manual

4
Physical Details
Front Panel
Lens
No physical adjustment is required or possible for the lens, but
you should ensure that the lens cover remain clean. The
image quality is degraded if the lens cover is dirty or
smudged.
Microphone
The built-in microphone is mounted on the front.
Power LED
(Green)
On - Power on.
Off - No power.
Blinking - The Power LED will blink during start up. This will
take 15 to 20 seconds.
Active LED
(Green)
Off - No user is viewing the camera.
Blinking - User(s) is viewing the camera.
Network LED
(Green)
On - Wireless or LAN connection is detected.
Off - Wireless or LAN connection is not detected
Blinking - Data is being transmitted or received via the LAN
or Wireless connection.
Rear
Antenna
(WCS-0010 Only)
Attach the supplied antenna here. The antenna is adjustable;
best results are usually obtained with the antenna positioned
vertically.
SPKR out
If required, an external speaker can be plugged in here.
Power Input
Connect the supplied 5V power adapter here. Do not use
other power adapters; doing so may damage the camera.
LAN port
Use a standard LAN cable to connect FCS-0010/WCS-0010
to a 10/100BaseT hub or switch.
Note:
• Attaching the LAN cable will disable the Wireless
interface. Only 1 interface can be active at any time.
• The LAN cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching
the LAN cable while the camera is powered on does NOT
switch the interface between wired and wireless.
Reset Button
This button is recessed; you need a pin or paper clip can be
used to depress it. It can be activated at any time the camera
is in the "ready" mode.
• Restore to Default IP Address. When pressed and
released, the FCS-0010/WCS-0010 will reset to DHCP
Client.
• Restore to Factory Default setting including IP
Address, Administrator ID, and Administrator
password. When pressed and held for 3 seconds, the IP