LevelOne User Manual FNC-0107TX 10/100Mbps PCI Fast Ethernet Adapter V6.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This device complies with Part 15 of the FCC Rules.
Introduction Hardware Overview The FNC-0107TX adapters are highly integrated and cost-effective single-chip Fast Ethernet Adapter that provides 32-bit performance, PCI bus master capability, and full compliance with IEEE 802.3u 100Base-TX specifications. This adapter supports both 10Mbps and 100Mbps network speed, 100BaseTX operates on two pairs of category 5 UTP cable and 10BaseT operates on Category 3, 4, 5 UTP cable. With the Auto-Negotiation technology, network speed is auto detected.
Features & Benefits Compliant to PCI Revision 2.1/2.2 Supports a 32-bit general-purpose timer, referenced by the external PCI clock source, and timer-interrupt Supports ACPI, PCI power management Complies with the IEEE 802.
Installation Hardware Installation To insert the FNC-0107TX into your computer, follow the steps list below. 1. Turn off the computer and remove its cover. 2. 3. 4. Insert the adapter into a PCI slot. Secure the adapter to the rear of the computer chassis and put back the computer cover. Connect the adapter to the network using twisted-pair cables. Hardware Requirement for Wake-On-LAN The motherboard must support PCI 2.2.
Driver Installation Use the drivers supplied by the CD included in the adapter. For detail description, please refer to "help" in the CD provided by the adapter. Troubleshooting If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub complies with the adapter specification, such as 10Mbps 10Base-T or 100Mbps 100Base-TX. Then recheck the LED. The adapter provided one LEDs to indicate network status.
Wake-On-LAN The PC does not boot up when a Magic Packet or Wake up Frame is sent. 1. 2. 3. 4. Check the specification of this PC meets the hardware requirement. Enable the WOL function or the power-ON function of the PC. Verify the BIOS setting of Wake-On-LAN is configured properly. The name of this function is system dependent, but may be located in a category heading titled something like Power Management.
Specification Topology Connector Standard Star RJ45 IEEE802.3 10Base-T, IEEE802.3u 100Base-TX Transmission Rate Hardware IRQ Line I/O Address Drivers 100Mbps or 200Mbps PCI Local Bus Master 2.1/2.2 Support (Supports PCI 2.2 ACPI Power Management Wake-On-LAN) Assigned by system Assigned by system ODI driver for NetWare 3.x, 4.
Technical Support Thank you for selecting LevelOne products. LeveOne’s website contains the latest user documentation and soft-ware updates for LevelOne products. Please contact LevelOne Technical Support through our website. World Wide Web http://www.level1.
