User manual

- 19 -
UDP - This protocol allows for more real-time audio and video streams. However, network
packets may be lost due to network burst traffic and images may be broken. Activate UDP
connection when occasions require time-sensitive responses and the video quality is less
important.
LED Control
Select from the drop-down list to adjust the brightness of the camera’s LED. Click Apply or
Reset to take effect.
/ Recording on/off: shows the status of recording video
/ MIC on /off: shows the status of MIC volume.
/ MD on/off: shows the status of Motion Detection
 Camera Control Panel - There are two slider bars and eight control buttons on the remote
controller. They are describe as below:
 Brightness and Mic volume adjustment - Drag the slider bar to adjust the image
brightness level and Mic volume. Click “Default” for default brightness setting and “Mute”
for no sound. For more Audio setting, please refer to the Audio configuration on page 22.
 Speaker –You can output the audio form the computer’s audio input terminal to the
camera’s built-in speaker output.
Play or Stop - Click this button to play or stop the video.
Recording - Click this button to record video to your computer.
Snapshot - Click this button to capture and save still images.