User Guide

8.0 Device and Alarm Testing

The Level Sense Pro and sensors should be tested monthly to ensure

proper operation.

8.1 Humidity and Temperature Testing

Testing for temperature and humidity sensors is done by comparing

current levels in Portal with a calibrated reference. Readings of +/-3%

are expected.

8.2 Float Switch Testing

8.3 Leak Sensor Testing

Test the leak sensor by dipping both metal tabs of the sensor into

a cup of water and waiting 60 seconds for an alarm. Do not submerge

the plastic housing of the sensor. Dry the metal tabs and replace the

sensor after testing.

8.4 Power Loss Detection Testing

Test power loss detection by removing the power adapter from the

wall and waiting for alarm. Reconnect the power adapter after testing.

8.5 Battery Condition Testing

Remove the power adapter from the wall and allow the device to run

before three hours replace the battery. Dispose battery according to

local rules and regulations.

9.0 Maintenance

Level Sense Pro and sensors require the following monthly

Inspect the leak sensor contacts for corrosion and clean or replace

Check the level sensor has not come loose from the

PVC pipe. Check for fraying wire, loose connections

or other general wear and replace if necessary.

7HVWWKHȵRDWVZLWFKE\KROGLQJWKHȵRDWXSVLPXODWLQJKLJKZDWHU

DQGZDLWLQJVHFRQGVIRUDQDODUP5HOHDVHWKHȵRDWDIWHUWHVWLQJ