Datasheet

Leuze electronic GmbH + Co. KG In der Braike 1 D-73277 Owen Tel. [phone] PRK 318B … - 06
[e-mail] • www.leuze.com
Mounting options
Standard mounting
Alignment of the supplied mounting nuts with flat side towards the mounting sheet.
Mounting bracket BT D18M.5 is recommended for standard mounting.
omni-mount
omni-mount makes fine adjustment of the sensors possible in a very simple and economical manner. For this type of mounting,
the mounting nuts are used with the round side towards the mounting device. The mounting sheet must have a bore hole of
approx. 21mm in diameter. The special molding of the mounting nuts together with the spacer disc included in the delivery con-
tents allows form-locking fastening of the sensors at different adjustment angles. The maximum possible tilt angle depends on
the thickness of the mounting sheet. Mounting bracket BT D21M is recommended for omni-mount.
*) Corresponds to the thickness of the BT D21M mounting bracket
Embedded mounting
Embedded mounting, e.g. into a materials handling belt, is possible via the BT 318P-LS mounting support.
The supports can be used either for fastening the axial sensors or for sensors with 90° optics.
.
Mounting sheet thickness Max. adjustment angle
2 mm +/- 5°
4 mm
*)
+/- 8°
PRK 318B Retro-reflective photoelectric sensors with polarization filter