Datasheet

Fast commissioning / operating principle
Leuze electronic MA 248i 15
TNT 35/7-24V
Recommendation
In most cases, the 4-byte module is sufficient for the output module.
A larger module is needed, for example, if a BCL bar code scanner is to be configured by
means of PT-sequences, or an RFID transponder is to be described. In these cases, larger
data modules are usually sensible.
Notice!
Examples for selecting the correct data module length can be found in chapter 12.3.4,
section "Examples of sensible settings for corresponding Leuze devices" on page 68.
3.5.5 Transfer of the configuration to the IO Controller
 Transfer the PROFINET-IO configuration to the IO Controller (S7 PLC)
After the correct transfer to the IO Controller (S7 PLC), the PLC automatically carries out
the following activities:
• Check device names
• Assignment of the IP addresses that were configured in the HW Config to the
IO devices
• Establishment of a connection between the IO Controller and configured IO devices
• Cyclical data exchange
Notice!
Participants that have not been "named" cannot be contacted yet at this point in time!