Manual

12
(Remember, when possible, it is better to make
the initial windage adjustments to the mount
base before using the scope’s windage adjust-
ment.) Turn the windage adjustment until the
vertical crosshair of the scope covers the center
of the collimator crosshair.
4.
Adjust the elevation until the horizontal
crosshair of the scope covers the center of
the collimator crosshair. With that, the scope should align with the axis
of the bore, as shown in Figure B.
5.
Remove the collimator spud from the barrel.
NOTE: Bore-sighting alone is not sufficient to sight-in a scope. You must make
final adjustments by shooting the firearm using the same ammunition you use
in the field.
T RADITIONAL BORE - SIGHTING (B OLT A CTIONS )
Preliminary sighting-in can also be accomplished by bore-sighting at the
firing range using a target from 20 to 50 yards away.
Figure B