User's Manual

17
until the thin knurled ring is flush with the turret housing. To install
the dial assembly without engaging the hard stop, push the dial to-
ward the maintube until you feel the first detent and the thin knurled
ring is 1/8" above the turret housing. Secure the set screws.
WINDAGE ADJUSTMENTS FOR THE LEUPOLD MARK 8 CQBSS
Windage adjustments can be made by pinching the dial on the right
side of the scope and rotating the windage adjustment. To move the
point of impact to the right, rotate the adjustment counter clockwise.
To move the point of impact to the left, rotate the adjustment
clockwise. Each click of the windage dial will move the point of impact
0.1 milliradian. The windage dial can be rotated 5 milliradians to the
left of center and 5 milliradians to the right of center, for a total of 10
milliradians when the hard-stop is engaged.
For additional windage travel, the adjustment can be set to allow
multiple revolutions by loosening the set screws and lightly pulling
the dial away from the maintube until the detent is felt and the
knurled ring is located approximately 1/8” from the turret housing,
then re-tightening the screws.
To engage the hard-stop and limit the windage dial to one revolution,