Manual

5
CARRY HANDLE MOUNTING PROCEDURE
Preparing the Leupold Mark 4 CQ/T 1-3x14mm scope for carry handle mounting:
1. Insert the carry handle mounting stud into the center hole in the scope
mounting foot and make it snug using only your fingers. This stud will be
securely tightened when the stud nut is tightened.
Mounting the Leupold Mark 4 CQ/T 1-3x14mm scope on a carry handle:
1. Insert the mounting foot into the sight groove of the carry handle so that
the scope’s mounting stud passes through the carry handle’s mounting
stud hole and the foot rests firmly in the sight groove of the handle.
2. Thread the carry handle mounting stud nut onto the mounting stud.
3. Place the firearm to the shoulder to ensure that full eye relief is available.
If lesser or greater eye relief distance is required, return to Step 1. under
“Preparing the Leupold Mark 4 CQ/T 1-3x14mm scope for carry handle
mounting” and place the stud in either the first (as measured from the
eyepiece, to mount the scope further forward) or third (to mount the
scope further back) mounting foot hole and repeat the procedure.
4. Secure the mounting stud nut using a wrench or other appropriate tool
until it is firmly seated against the carry handle.