Manual

4
3. Remove the scope from the rail and attach the flat-top mounting bracket
to the mounting foot of the scope so that the hex nuts are on the same
side of the scope as the windage dial, the longer points of the mounting
bracket rails engage the mounting grooves on each side of the mounting
foot, and the cross bolts are seated between the cross braces. (The mount
rails can be mounted with the hex nuts on the opposite side but the
suggested configuration avoids snagging of clothing during operation.)
4. Return the scope with the mounting bracket to the MIL-STD-1913 mounting
rail in the same position noted for a full sight picture.
5. Make certain that both mounting foot lugs engage the MIL-STD-1913
mounting rail cross slots and that the mounting bracket rails hook over
each side of the MIL-STD-1913 mounting rail.
6. With one hand atop the scope pressing down and forward to ensure a
solid mount engagement, finger tighten the hex nuts of the mounting
bracket until the assembly is snug.
7. Using a 1/2-inch hex wrench or socket, alternately tighten each nut until
the mounting bracket is secure.
8. Complete the installation by using a torque wrench and 1/2-inch socket to
apply 65 inch-pounds of torque to each hex nut. (The use of the Mark 4
Torque Wrench is recommended for this procedure.)