Manual

3
2. Firmly press the battery pack all the way into the chamber until it will not
go any further and the battery cap lip is in line with the adjacent battery
pack seating notch in the scope’s maintube.
3. Rotate the battery pack by the battery cap until the battery cap lip seats
in the battery pack seating notch and will turn no further.
FLAT-TOP MOUNTING PROCEDURE
Preparing the Leupold Mark 4 CQ/T 1-3x14mm scope for flat-top (MIL-STD-1913)
mounting:
1. Loosen the 1/2-inch hex nuts of the mounting bracket until they are near the
end of its cross bolts.
Mounting the Leupold Mark 4 CQ/T 1-3x14mm scope on a flat-top (MIL-STD-1913)
mounting rail:
1. Place the Leupold Mark 4 CQ/T 1-3x14mm scope atop the MIL-STD-1913
mounting rail so that the mounting foot lugs of the mounting foot engage
the cross slots of the rail.
2. Holding the scope in place, check the eye relief of the scope; adjust the posi-
tion of the scope as necessary until the mounting foot lugs engage the rail’s
cross slots in a position that allows for a full sight picture when the firearm is
shouldered. Note this position.
Mounting the Scope