Manual

8
2. Turn the eyepiece clockwise until it stops and the thumb or index
finger rests against the lower right side of the scope. That position is
3x magnification.
3. Turn the eyepiece counter-clockwise until it stops and the thumb or index
finger rests just behind the illumination control dial of the scope. That
position is 1x magnification.
ILLUMINATION
The illumination of the reticle of the Leupold Mark 4 CQ/T 1-3x14mm scope
is controlled through the illumination control dial, located atop the scope
just in front of the magnification selector. It features, rotating clockwise,
twelve positions:
1. OFF
2. Illumination settings one and two (indicated by the two smallest dots on
the dial) for use with night vision equipment.
3. Illumination settings three through ten (indicated on the dial by dots of
increasing size).
4. A battery check setting (indicated on the dial by the image of a battery)
that will illuminate the reticle only if the battery contains 1.2 volts of
charge or more. If the battery is running low, the reticle will blink continu-
ously.
As the dial is composed of elevated rays emanating from its center, each being