Manual

LGT 1’ Extension
4
Step 11 Take the Wire Harness Extension and crimp each butt connector to its
counterpartonthetrailer’swireharness.Theyellowwirewillconnecttothegreentrailerwire
whenworkingonthepassengerside.
Step 12Reattachthetwotaillightbrackets.Determinehowmuchoftheextendedwire
harness to remove and make the necessary cuts. Again, strip about ½” insulation from
eachwire,andthreadintothecorrespondingholesontherearofthetaillight.
Step 13Cuttwo2”lengthsofelectricaltape(notsupplied)andapplyoverthewiringandagainstthebackofeachtaillight
tosecurethewiringinthegroove.Inserttaillightstudsthroughtheirrespectivebrackets,placealockwasherandnuton
outside studs and tighten.
Step 14CrimpaRingTerminaloneachwhitewireandplaceoverinsidestudsfollowedbylockwashersandtheremain-
ing nuts. Tighten the nuts.
Step 15SlipthetwoRibbedCableProtectorSplicesontothewiringandhalfwayintotheexistingcableprotectoras
shown.Slipthe1’lengthsofribbedcableprotectorontothewiringandoverthesplices.Cuttolength.Securethewiringto
insideofLGTframewithzipties.
Replace the end gate.
For assistance, contact Let’s Go Aero at 877-464-2376 or 719-630-3800, or
[e-mail].Visitourwebsiteatwww.LetsGoAero.com