Manual

LGT 1’ Extension
2
Step 1: Remove Hardwares
Removerearendgatesupportsandhardwarefromrearoftrailerbodytoincludelatches,brackets,andtaillightassem-
blies. Set aside.
Assembly
Step 2: Install Extension Tubes
LocatethetwoInsideFrameTubes(IFT)andthefour5/16”SpringNuts.Usingthe7/16”wrench(orastickofwood)push
aspringnutintooneofthetubessothatitalignswithoneoftheholesinthetube.Repeatthisprocessfortheotherthree
spring nuts and the second IFT.
Locatetwo5/16x2”bolts,twoatwashers,andtwolockwashers.InstalltheIFTsandsliptheOutsideFrameTelescope
Tubes over them, but do not secure.
Step 3: Install U-Tubes
PlacetheBodyStyleU-TubeontheFrameTubesandkeepinplaceusingtwo5/16”X2”bolts.PlacetheEndGateStyle
U-TubeontheFrameTubesasshown.KeepitinplaceusingthetwoEndGateSupportBracketboltsremovedearlier.
Step 4: Attach Side Panels with Corner Coves and Insert Pin Nuts
SlipthefourPinNutsintotheholesnearthetopsoftheFrameTubes.HangthetwoSidePanelswithcornercovesonthe
U-Tubes.YouwillwantthePinNutstoprotrudeslightlythroughtheSidePanels.
Step 5: Attach C-Channel Extensions
AttachthetwoC-ChannelExtensionstotherear(#10U-Tube)PinNutsusingtwo5/16”X1”bolts,two5/16”lockwash-
ers,andtwo5/16”atwashers.LeavethefrontendoftheC-ChannelExtensionunsecured.