PREPARATION L WE STRONGLY RECOMMEND THAT A LICENSED AND INSURED PROFESSIONAL CONTRACTOR TO INSTALL THIS PRODUCT INCLUDING THE ASSISTANCE OF A SECOND PERSON DURING INSTALLATION. 2. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are included in the package by marking all the components on the “Detailed Diagram of Shower Door Components”. Examine boxes and packages for shipping damage.
—==7 ANY J 7 | Heine I Troy | = I rit Water Strip I Tne | z Side Strip PCs & Wall Profile 1pe [5 | cane [im] [7 | PredGistvihgisprotia Glass Door spec 8 Bottom Bracket 1pc [oT Romrmssaairina Countersunk Screw M4x45 pecs 42 Wall Anchor 11 pes FAINTHEARTED INSTALLATION INSTRUCTIONS FOR FUTURE REFERENCE! www.
INSTALLATION INSTRUCTION Here I A. Attach the hinges (1} to the glass door {4). Mount the handle (3) and slide the side anti-water Strip (2) to the glass door (4). See Figure 1 for details. B. Place a piece of flat timber (about 5/8" thick) on the threshold or the shower base. Place the glass door (4) onto the flat timber. Butt up the door with hinged side against the wall carefully, adjust its position and level it vertically.
Lore 3 C. If your shower door is with a fixed glass panel, please follow these steps. Place the wall profile (6) centrally and vertically above the threshold or shower base. Using a level adjust the wall profile upright, then make the marks through the prevailed holes on the aluminum profile for drilling. Now drill the holes with drill bit (®8mm) and insert the wall anchor fasten the profile to the wall with countersunk screw M4x45 (10). See Figure 3 for details. D.
Figure 5 E. Adjust the position of the whole shower door. Then drill 3 holes with drill bit one is in the middies on the overlapping of the profiles, the other two are 150mm up and down from the top and bottom of the profiles. Secure the glass & wall profile with screw ST3.5x12 (9) then cover the screw covers (11). See Figure 5 for details. Fare 6 www. Carelessness F. Seal with silicone caulk between wall, glass and tray or ground. WAIT 24 HOURS BEFORE USING THE SHOWER ENCLOSURE See Figure 6 for details.
PRODUCT MAINTENANCE To ensure long lasting life of your glass shower products, wipe them off after each use with a soft cloth. Rinse and wipe off the glass using either soft cloth or squeegee to prevent soap buildup. Never use abrasive cleaners and cleaning products that contain scouring agents as this may scratch the surface. Never use bristle brushes or abrasive sponges. To ensure a long lasting hardware finish, wipe off the metal parts after each use with a soft cloth.
