Installation Guide

a.
b.
c.
Figure 14
Figure 15
www.lesscare.com
ULTRA-D
TUB DOORS • SHOWER DOORS
INSTALLATION STEPS
20
13. Hang the Glass Door Assembly to the Upper Guide
Rail (2), put the bottom edge of the glass door to the slot of
the Guide Block (10). Make sure that the glass door will
not touch the metal part of the Guide block.
See Figure 14 for details.
14. Slide the Side Anti-water Atrip (14) to the Station-
ary Glass (11), remove the flapper that interfere with
the Upper Guide Rail (2) with scissors.
See Figure 15 for details.
NOTE: You can cut the strips to size by using a knife if
necessary, do not cut anti-water strips while they are
installed on the glass. You must take off the anti-wa-
ter strip cut them as needed and re-install them.
Normally, the strips are pre-cut to the size of the glass
door.
6
14
4
10
14
10