Installation Guide

www.lesscare.com

ULTRA-C

TUB DOORS • SHOWER DOORS

INSTALLATION STEPS

Figure 12

Figure 13

12. Hang the Glass Door Assembly to the Upper Guide

Rail (4), put the bottom edge of the glass door to the slot

of the Guide Block (13). Make sure that the glass door

will not touch the metal part of the Guide block.

See Figure 12 for details.

13. Slide the Side Anti-Aater Atrip (8) to the Stationary

Glass (16), remove the flapper that interfere with the

Upper Guide Rail (4) with scissors.

NOTE: You can cut the strips to size by using a knife if

necessary, do not cut anti-water strips while they are

installed on the glass. You must take off the anti-water

strip cut them as needed and re-install them. Normally,

the strips are pre-cut to the size of the glass door.

See Figure 13 for details.

inside

Outside