Installation Guide

Figure 6

6. Towel Bar and Wheel Installation.

6.1 Install the Towel Bars (8) onto the Glass Doors(5).

IMPORTANT: Make sure CLEAR RUBBER GASKET are

in between the glass door and towel bar; between the

cap and glass door. Mark sure CLEAR RUBBER SLEEVE

are inside the glass hole. Do not let any metal part of

the Towel Bar to contact the glass directly.

6.2 Install the 4 Wheels (2) onto the Glass Doors (5).

IMPORTANT: Make sure RUBBER SLEEVES are inside the glass holes.

6.3 There are 3 sets of holes on the wheels, which are used to adjust the height of the glass doors. Usually the small rollers will

be pre-installed in the middle holes. The smaller rollers can be installed in the upper hole or lower hole if the glass height

needs to be adjusted, but make sure that the METAL GASKET are installed between the screw and the metal roller body.

When the roller is installed in the upper hole, the glass door height will go down 2.2mm; when the roller is installed in the

lower hole, the glass door height will go up 2.2mm.

See Figure 6 for details