Installation Guide

4. Wall Profile and Rubber Bumper Installation.

Figure 4

∅8

a b c

Figure 5

back edge

4.1 Place the Wall Profile (3) vertically against the wall and insert it into the Bottom Track (10).

Using a level to level the Wall Profile upright, mark 3 pre-drilled holes on the wall, using a pencil or marker, to prepare

for drilling.

4.2 Now, drill 3 holes in the wall using 8mm (5/16”) Drill Bit. Apply silicone into the holes on the wall. Insert 3 Wall

Anchor (6) and hammer them in.

4.3 Apply silicone from top to bottom along the back edge (edge facing the wall or shower tray) of Wall Profile and

Bottom Track.

4.4 Put the Wall Profile against the wall and insert it into the Bottom Track again. At the top and bottom holes, put the

Rubber Bumper (4) against the holes, and secure the Wall Profile and Rubber Bumpers to the wall by using 2 Round

Head Self-tapping screw M4X60 (7). For the middle hole use only Round Head Self-tapping screw M4X60 to secure the

Profile

to the wall.

Note:TheotherWallProfilewillbeinstalledinthesameway.

See Figure 4 for details

5. Insert the Upper Guide Rail (1) into the wall profiles.

See Figure 5 for details