Installation & Assembly

www.lesscare.com
INSTALLATION INSTRUCTIONS
LB2C
LAVATORY FAUCET
2
1
3
4
Turn off water at the supply valve under the sink or at the
main water supply, disconnect the supply line,and remove
old faucet.Clean and dry surface area where new faucet will
be mounted.
Place new faucet through holes in top of sink. From
underside, slide washers onto threaded rods. Secure with
washer and nuts.
POP -UP DRAIN INSTRUCTIONS:
Remove the stopper (1) and all the way down, and push
the flange (2). Screw the nut (3) gasket (4) down.
5
6
Connect water supply lines.(1) Use 1/2" IPS faucet
supply lines or (2) use coupling nuts (not supplied) with
(3) ball-nose risers (not included). Turn water supply or
shut-off valve back on and check for leaks. If leaks
occur, gently tighten the faucet connections.
Apply silicone to the underside of the flange (1).
Insert the pop-up body(2)into sink. Screw the flange (1)
onto the pop-up body (2). The pivot hole (3) must face
the back of the sink. Use the groove joint pliers to tighten
the nut (4), but do not over tighten. Do not turn the pop-
up body (2) while tightening the nut (4) or the sealant
may not seal properly. Clean away any excess putty.
Insert thread end of pop-up assembly (E) up through
drain hole (6.1) and attach flange (6.2) to pop-up
assmbly (E).Tighten the flange (6.2) until the gasket is
tight against the underside of the sink. The preassembled
fitting arm (6.3) for the pop-up assembly (E) should face
the rear of sink after you finish tightening.
7
8
Remove the pivot nut (1). Install the horizontal rod (2)
and the stopper (3), as shown (4). Hand tighten the pivot
nut (1). Attach the horizontal rod (2) to the strap (5) using
the clip (6).
Important: After installation is completed, remove aerator.
Turn on water supply and allow both hot and cold
water to run for at least one minute each.While water is
running, checkfor leaks. Replace aerator.Tighten nuts
slightly to stop minor leaks.
1
2
3
1
2
4
3
SILICONE
1
2
3
4
2
1
3
4
5
6
4
3
1
2
Maintenance Your new faucet is designed for trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these
will dull the finish and void your warranty.