Installation & Assembly

www.lesscare.com
4
LB16B
BASIN FAUCET
INSTALLATION INSTRUCTIONS
You should clean all the dirts from valve
outlets. Turning off the water supply
valves. This is usually found near the water
meter. If you are replacing an existing
faucet, remove the faucet from the sink
and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the
O-RING is placed onto the bottom of Base
Ring. Install faucet through hole in sink.
From underside sink, Put Plastic Washer
and Mounting Nut. Position faucet on sink
properly and tighten Mounting Nut.
Make sure the O-RING is placed onto the
bottom of Base Ring. Install faucet through
Deck Plate. From underside sink, Put Plasetic
Washer and Mounting Nut. Position faucet on
sink properly and tighten Mounting Nut.
If necessary, tighten screws using a
adjustable wrench until the faucet is firmly
connected to the sink.
Connect hot and cold water supply lines to
the water Supply Valves
As shown. lnsert Flange with Washer
through Sink drain Hole. From underside,
thread Drain Body into Flange. Holding the
drain body in position with Ball Rod
Opening facing back, tighten Metal
Locknut securely. Thread Drain Tailpiece
into Drain body.
1 2
4 5
6
87
3
After installation is complete, remove
Spray head and rotate handle to the close
position. Turn Water Supply Valves on, and
check all connections for leak. Flush faucet
by running hot and cold water in full
position for one minute. Re tighten the
Spray Head.
Lift the handle up, the cartridge will be
activated allowing water to flow. The
water flow will increase by continuing to
rotate handle. By roatating the handle to
the right, the water temperature will
decrease to cold flow only. By rotating
handle to the left, the water temperature
will increase to hot only.
Close
Open
Hot
Cold