User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
35
CANADA - ISED!
(Innovation, Science and Economic Development Canada)
Labeling requirements "
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on the
outside of the final product enclosure must display the following text:"
Contains Model emMesh 1.31 Radio, IC: 24776-EMMESH"
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003."
Detachable antenna "
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that necessary for successful communication. "
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec
une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire àl'établissement d'une communication
satisfaisante.(