User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
31
Regulatory Informations
United States (FCC)
emMesh 1.31 RF Modules comply with Part 15.247 of the FCC rules and regulations. Compliance with
the labeling requirements, FCC notices and antenna usage guidelines is required. To fulfill FCC
Certification, the OEM must comply with the following regulations:"
The system integrator must ensure that the text on the external label provided with this device is
placed on the outside of the final product. "
RF Modules may only be used with antennas that have been tested and approved for use with the
modules."
OEM labeling requirements"
As an Original Equipment Manufacturer (OEM) you must ensure that FCC labeling requirements
are met. You must include a clearly visible label on the outside of the final product enclosure
that displays the following content:"
Contains FCC ID: 2ASI4EMMESH &
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1.) this device may not cause harmful interference and (2.)
this device must accept any interference received, including interference that may
cause undesired operation."