User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
25
TableLvl1 0x21"
List ID modules that are present in the level of table 1. For asked each index 8 ID will be send. The
possible index values are from 0 to size max / 8, rounding up if size max / 8 does not give a whole."
DebugInfos 0x22"
Information on the module. See the documentation on the module concerned for details."
Settings 0x23"
Returns module parameters. See the documentation on the module concerned for details."
Rssi 0x24"
Returns signal strength. See the documentation on the module concerned for details."
MasterID 0x25"
Returns the master ID."
NackInfos 0x2B"
Confirmation of non-receipt of the message. The message ID of the header "Mesh" is returned in the
payload to indicate which message failed."
DecryptionError 0x2C"
Decryption error detected. The message ID of the header "Mesh" is returned in the payload to indicate
on what message the error occurred."
0x1D
0x21
Index
Max
8 x ID [4]