User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
22
TypeID "
Returns module identification information within a "CSV""
Structure of the typeID varies according to the device name. "
See the documentation on the module concerned for details."
Example of "CSV" structure: "device name, firmware version, hardware version Version EEPROM
memory" "
Refresh "
Return the module information. The type refresh must provide at least 3 information which are: the level
relative to the origin of the request, the relay used to communicate with the origin and the ID of the
group. The rest of the payload is variable depending on the module, see the documentation on the
module concerned for details."
Table 6: Structure of the refresh type payload"
DataWithoutAck"
Back / Sends data without reception confirmation."
DataWithAck"
Back / Send data with confirmation of receipt. Upon receipt of a message type dataWithAck a message
subtype ackData will be sent to the origin."
Payload []
Value
Description
0
0x01
Typepayload
1
0x00 - 0x1E (invalid: 0x1F)
level compared to the original
2 to 5
Relay
6
0x00 - 0xFF (default: 0xFF)
Group ID
7 to...
Module Based.