User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
17
Encryption (6 bits)
Message Type (1 bit)
Encryption Type <6: 0>
Value
Description
No
0x00
Raw message, no
encryption
Polymorphism
0x01
Simple light cypher
algorithm based on
polymorphism of
paraphrase.
Rijndael [CBC]!
0x02
Rijndael implentation
cypher. (Not on emMesh)
AES 256bits
0x03
AES-256 standard (Not on
emMesh)
RSA 2048
0x04
To come
256 bits ECC
0x05
To come
User Defined
0x06 to 0x7F
Supported only by certain
devices
Message Type <7>
Value
Description
Simplified
0x00
Set following message as
being in simplified mode
Advanced
0x01
Set following message as
being in advanced mode