Submittal Sheet

ASSE 1017 Certified
cUPC Certified
HIGH LOW
THERMOSTATIC
MIXING VALVES
Submittal Data Sheet S-2006SW-LF
April, 2020
XL-200-SW-LF-BDT____
5-208 GPM (18.9-787 l/min)
• High Low Thermostatic Water Mixing Valve with
5 GPM (18.9 l/min) minimum flow capacity
• 2” inlets, 2” outlet (51 mm x 51 mm)
• Outlet dial thermometer and ball valve
• Integral combination checkstops with strainers and
wall support (SHIP LOOSE)
• 125 PSI (8.6 BAR) maximum operating pressure
• Copper encapsulated thermostatic assembly with
Teflon coated stainless steel shuttle
• Locking temperature regulating handle set for
120°F(49°C)*
• Temperature adjustment range, 95-135ºF (35-57ºC)
**
• Internal parts of stainless steel
• Rough Bronze Finish
*NOTE: A locking temperature regulator set for 120°F (49°C), is
simply a mechanical setting to prevent unauthorized temperature
set point changes. If incoming water is hotter than 150°F
(65.5°C), the temperature of the factory test, the valve may deliver
in excess of 120°F. MUST BE RESET BY THE INSTALLER
5 10 15 20 25 30 35 40 45 50 PSI
0.3 0.7 1 1.4 1.7 2.1 2.4 2.8 3.1 3.4 BAR
5 69 96 117 135 148 163 174 188 198 208 GPM
18.9 216 363 443 511 560 617 659 712 750 787 l/min
PRESSURE DROP
60(227)
0
80(303)
100(379)
120(454)
140(530)
160(606)
180(681)
200(757)
5
(0.3)
10
(0.7)
15
(1.0)
20
(1.4)
25
(1.7)
30
(2.1)
35
(2,4)
40
(2.8)
45
(3.1)
50
(3.4)
PRESSURE DROP
PSI(BAR)
220(833)
FLOW RATE
GPM(l/min)
ECO-MIX
™
OPTIONS
____SUFFIX LWS Less wall support
____ SUFFIX TC Test connection (shipped loose)
____ SUFFIX IT Inlet thermometers (shipped loose)
NOTE: Leonard Valve Company reserves the right of product or
design modification without notice or obligation
+
FLOW
MIN
+NOTE: The valve will maintain temperature with 0.5GPM flow
from the domestic hot water loop when properly installed near the
hot water source with a continuously operating recirculation pump.
**NOTE: For temperatures outside of this valve’s stated range,
please see our line of bi-metal valves.
40
20
100
30
20
0
°F
140
LEONARD
60
°C
0
-10
10
120
R
40
50
60
80
NOTE: Sweat inlets & outlet, checks shipped loose
This valve is certified to meet Low Lead requirements of
wetted surface area containing less than 0.25% lead by
weight. All other component accessories, the sum total
of which comprise the wetted surface of this product,
contain less than one quarter of one percent lead by
weight.
BDT ASSEMBLY
IS A COMPONET ACCESORY
INCLUDED BY FACTORY
WARNING: This product can expose you to
chemicals including lead, which is known to the
State of California to cause cancer. For more
information, go to www.P65Warnings.Ca.gov
!