Manual

EDS94TA10030xxxx EN 1.2 - 11/2009 L 47
9400 Technology applications | Electronic gearbox
Parameter setting & configuration
Operating mode "Electronic gearbox"
5.4.3 Master value trimming
[5-7] "Master value trimming" function in the signal flow (schematic diagram)
This function serves to adjust the master value.
 Parameter setting: Tab Application parameters  dialog level Overview  Electronic
gearbox  Master value trimming
 Configuration: Tab FB editor  FB Trimming
n Master value with clutch
o Master value with trimming
M
v
Slave
Real master/
Virtual master
v
t
Dv
C03006 = 1

Parameter Lenze setting
Value Unit
C03674 Master value with clutch - unit/t
C03026 Activate trimming Deactivated
C03027 Positive trimming Inactive
C03028 Negative trimming Inactive
C03685 Positive speed 400.0000 unit/t
C03686 Negative speed -200.0000 unit/t
C03687 Acceleration ramp 1.000 s
C03688 Deceleration ramp 1.000 s
C03689 Disable ramp 1.000 s
C03690 Master value with trimming - unit/t
Control inputs of the function Signal configuration
Lenze setting Control input (Multiplexer parameters)
C03026  Activate trimming C03058/16
C03027  Positive trimming C03058/18
C03028  Negative trimming C03058/19