Owner manual

L Firmware 1.37 - 09/2006 447
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
15.6.2 Reset of error message
An error message with the response "Fault", "Trouble", "Quick stop by trouble" or "Warning
locked" must be explicitly reset (acknowledged) after the cause of the error has been
eliminated.
M To reset (acknowledge) a pending error message execute the device command
C00002
= "43".
O Tip!
With an online connection to the controller, use the Diagnostics tab of the
»Engineer« and click Error message reset to reset a pending error message.